Free Shipping On All orders Over $100

  Home > Lowers > Lower Parts >

KNS Hammer and Trigger Pin Mod. 2 Non Rotating .154 Inch BLACK
KNS Hammer and Trigger Pin Mod. 2 Non Rotating .154 Inch
 
Price: $33.00
Sale Price: $29.99
Savings: $3.01

Quantity in Stock:(Out of Stock)

Free Shipping
Availability:: Usually Ships in 24 Hours
Product Code: NRTHPMOD2-154-BLK
Qty:

Description
 
These are the Generation 2 Mod 2 pin sets. They are the STRONGEST pins that can be produced and were designed to withstand the high impact of full and semi-automatic 9mm and .223 suppressed weapons.

The pins are stainless steel pins. End retainers are black oxide, dark earth, or OD green. An absolute must-have for all M-16 owners. They will also protect your AR-15. Special anti-creep retainers prevent wear on your irreplaceable M-16 or AR-15 receiver. Pin installation tool & 2 Allen wrenches included. No modification to gun required.

The .1555 dia. pin is for worn receiver trigger and hammer pin holes. Being non-rotational, further wear is eliminated. They will also fit new receivers and will remove the free-play in match triggers. The .1555 will not fit Jewell Trigger System.

The .170 size fits late model Colts.

For Rock River National Match triggers use the .1555 only.

There is no difference in strength between the Gen 2 and the Gen 2 Mod 2 sideplates. The only difference is cosmetic.

Instructions: Trigger pin is internally threaded on each end. Use pointed tool to simultaneously push out old trigger pin and feed in new trigger pin. Push out old hammer pin about 1/8th" with a punch and finish pushing out with new hammer pin. Install connectors over ends of hammer pin and align holes over trigger pin. Install screws in trigger pin. Do not over-tighten, snug will do. KEEP WELL OILED.

Share your knowledge of this product. Be the first to write a review »